KRYPTON XPS-400 WHITE/PURPLE 65 W Nail Drill and 40,000 rpm. for manicure and pedicure
Professional 65W nail drill | 40,000 RPM maximum speed | High torque of 3.0 N·m | Heavy-duty brush micromotor with active handpiece cooling system | Advanced Protection+ intelligent overload safety circuit | Compact design (13.4x15.4x8.3 cm, 1050g) | Made in Ukraine with an official 24-month warranty on both the power unit and handpiece.
Technical Specifications Manufacturer: Bucos Innovation
Country of Origin: Ukraine
Power Output: 65 W
Rotational Speed: 0 – 40,000 RPM
Torque: 3.0 Ncm
Power Supply: 220–230 V / 50 Hz
Micromotor Type: Brush micromotor
Rotation Modes: FWD (Forward) / REV (Reverse)
Overload Protection: Yes – Protection+ intelligent safety system
Handpiece Cooling: Yes – active built-in air cooling
Base Unit Weight: 1050 g
Dimensions: 134 × 154 × 83 mm
Power Control Box Warranty: 24 Months
Micromotor (Handpiece) Warranty: 24 Months
100% Originalno
Brza dostava
Luksuzno pakiranje
Detalji proizvoda
The Krypton XPS-400 (Original) is an elite, professional-grade electric nail drill engineered to deliver uncompromised power, flawless precision, and heavy-duty reliability in high-volume beauty salons and podiatry clinics. Powered by an advanced high-torque motor matrix, the XPS-400 cuts through dense builder gels, acrylics, and severe podiatry calluses with absolute ease, maintaining consistent rotational speed under heavy resistance. The premium ergonomic handpiece is constructed with micro-balanced internal bearings that entirely eliminate hand-fatiguing vibrations, ensuring whisper-quiet operation and zero heat buildup during extended use. Equipped with a smart control dashboard for precise speed adjustments and seamless forward/reverse transitions, this original masterpiece is built to survive the rigorous everyday demands of top-tier nail technicians who refuse to compromise on technical architecture.
Station Setup: Place the Krypton XPS-400 base unit on a clean, flat workstation table away from direct dust airflow. Connect the heavy-duty handpiece cord cleanly into the front designated port.
Bit Installation: Twist the handle mechanism to open the standard chuck lock. Insert your chosen professional diamond or carbide drill bit fully into the opening, then twist back firmly to seal and lock the bit in place. Never operate the machine without a bit or blank pin locked inside the handpiece.
Powering On: Connect the main power cable to the wall outlet. Select your desired operational path (Manual/Hand control or Foot Pedal attachment) and turn the master switch ON.
Speed Regulation: Gently rotate the speed control dial to increase the RPM to your required technical level based on the current step (lower RPM for delicate cuticle mapping, higher RPM for swift product removal). Ensure you swap the Reverse/Forward directions only when the motor has come to a complete stop.
Maintenance After Care: Turn off the power switch after finishing the treatment. Disinfect the handpiece surface gently with a professional salon wipe and clean out any trapped micro-dust from the chuck zone weekly.
Recenzije kupaca
Budite prvi koji će ostaviti recenziju
0 recenzija
Još nema recenzija.
Često kupljeno zajedno
Ukupna cijena (3)
687,50 €
Povezani proizvodi
Pogledaj sve →
KRYPTON
KRYPTON III XPS-450 Nail Drill for 100 watts. and 45,000 rpm. for manicure and pedicure
